01926 451 744

Sacemi – SP cast iron immersion pumps / type SP 25 - 33

sp-25-33

Usages:
The pumps are suitable to transfer liquids containing impurities measuring up to 2-3 mm.
The hydraulic components, namely the impeller and scroll in PBT and the cast iron pump body allow the pumps to be used with water, emulsions and oily substances in general with a maximum viscosity of 3° Engler (21 CST).
The temperature of the liquid must not exceed 70° C.

They are usually used on:
Machine tools (milling machines – lathes – drills)
Surface treatment systems
Filtration systems
They should usually be installed on a tank, with a capacity in proportion to the flow rate, at about 3 – 4 cm. from the bottom. It is important to check that the maximum level of the liquid in the tank always remains 3 – 4 cm. lower than the flange (see figure).
In cases where the liquid is particularly dirty, the user is recommended to construct the tank in compartments to allow the dirt to deposit before it is stirred up by the pump.

For other usages you are advised to consult our technical office

sp-25-33-td