01926 451 744

Sacemi – EPC immersion pumps / type EPC 80B - 80C - 90B


These pumps are suitable for transferring clean liquids containing impurities measuring up to 30 micron.
The hydraulic components, namely the brass impeller, scroll and cast iron pump body, allow the pumps to be used with emulsions and oily substances, glycols and liquids in general, as long as they are not oxidative for the construction materials.
Viscosity must not exceed 3° Engler (21 CST).
The temperature of the liquid must not exceed 90° C.

They are usually used on:
Boring centres
Cooling exchanges
They should usually be installed on a tank, with a capacity in proportion to the flow rate, at about 3-4 cm. from the bottom. It is important to check that the maximum level of the liquid in the tank always remains 3 – 4 cm. lower than the flange (see figure).

For other usages you are advised to consult our technical office.